Shop › Forums › QnA › Bold case for B.mini ex
This topic contains 4 replies, has 2 voices, and was last updated by email@example.com 20 hours, 50 minutes ago.
Love the new cases, they look great.
Do you plan to make them available for B.mini ex?
At the moment I don’t have plan to produce the Bold cases for B.87EX or B.miniEX.
I hope you to understand that.
But if there are lots of request, I’ll think of it.
What would be required to remove the numpad section of the PCB to convert it to a standard mini?
Just following up on the above question. I already have a B.miniEX pcb fully soldered and good to go – however I am considering converting it to a b.mini without the attached numpad.
Is it as simple as removing the numpad section of the pcb or are there additional changes required?
A bad new and a good news!
* Bad news: No. the remains of miniEX without the numpad doesn’t fit a mini case.
* Good news : In a near future I’ll offer the “Bold” case for B.miniEX ^^
(Please a little more pationt.)
You must be logged in to reply to this topic.