Switches not working

[kmeyer1394Member]

For reference I have the B.mini EX. After soldering all of my switches in I hooked the board up to make sure all of the keys worked and to map them. They all did work so then I went on to solder in the LEDs. After finishing all of the LEDs now the right arrow key and all of the keys on the right edge of the board do not work (num -, num +, num enter, and the very top right key). All of the LEDs work however. Why would the keys all work before, then not anymore after installing the LEDs?

Also after installing the LEDs its like a few keys are always being activated. How can I reset the board so it was like it was when I got it with nothing mapped to see if it is the software or if it is a problem with the switches and they need to be replaced?

[flashteker@gmail.comMember]

Could you tell me which firmware upload?

(Correct firmware is ps2avrGB_NKRO.hex.)

I guess you uploaded the firmware for split one.

 

Thanks.

Hojin.Yi

[kmeyer1394Member]

I got it with the controller parts already soldered so it already had the firmware when I got it. I tried to reupload the firmware to hopefully reset everything including the key mapping to see if that would fix it. I did upload the firmware you said (ps2avrGB_NKRO.hex) and it seemed to fix it. So then I went back to the key mapper and uploaded the default mapping file and that also seemed to work. But then I went to change some of the keys so that I could control the LEDs and it went back to the non-working state like it was before where it acted like a few keys were stuck down. Also if it matters, the first time I did the mapping after I soldered the switches and before I soldered the LEDs, I didn’t use the default mapping, I just individually mapped every key and that worked just fine afterwards.

[kmeyer1394Member]

Never mind I ended up fixing it.

[brandowilliams94Member]

I am running into the exact same problem verbatim. Can you please explain how you fixed the right arrow and right column keys?

Any help is greatly appreciated!

[Author]

Posts