jasekourk14

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • January 11, 2017 at 11:13 am in reply to: Layer 5 #5107

    jasekourk14
    Participant

    I’m an idiot, I didnt push it all the way, it works now! Thanks, quick question I have an extra 4 popnut and screws for some odd reason or do they belong somewhere that I just overlooked.

    January 6, 2017 at 9:21 pm in reply to: Layer 5 #5078

    jasekourk14
    Participant

    It still didn’t have enough clearance between the m3 popnut and the m3. It still spins indefinitely. Is the popnut suppose to be able to move back and forth in between the 2layers, like it slides to the front and back, while looking at it from the table standpoint respectively.

    January 5, 2017 at 5:14 pm in reply to: Layer 5 #5072

    jasekourk14
    Participant

    I’m sorry this might have flew over my head, do you want me to poke at it through the slot until it rests a bit properly, or slide something small to hold it in place?

    January 5, 2017 at 7:35 am in reply to: Layer 5 #5067

    jasekourk14
    Participant
    This reply has been marked as private.
    January 3, 2017 at 1:23 am in reply to: Layer 5 #5049

    jasekourk14
    Participant

    Hey,

    the problem I’m having is the m3 pop nut and it being inside the layer 5, it keeps moving back and forth in the spot. I alligned the layer 5 by what is displayed in the pictures by the 1.2.3.4 slits towards the top. When I try to connect the layer 4 to 5 via the pop nut; it just leaves the frame able to move around on the table

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)