Marty

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 12, 2017 at 12:48 pm in reply to: Bold case for B.mini ex #7028

    Marty
    Participant

    Hi,

    Just following up on the above question. I already have a B.miniEX pcb fully soldered and good to go – however I am considering converting it to a b.mini without the attached numpad.

    Is it as simple as removing the numpad section of the pcb or are there additional changes required?

    Thanks

    Marty

    November 23, 2017 at 9:53 am in reply to: Bold case for B.mini ex #6947

    Marty
    Participant

    What would be required to remove the numpad section of the PCB to convert it to a standard mini?

    May 24, 2016 at 12:44 pm in reply to: RGB Diffuser with Aluminum Plate #3690

    Marty
    Participant

    Hi, have you had any luck sourcing a new supplier?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)